rbent Forum https://rbentonline.org/YaBB.pl General Category >> Technical >> converting direct to indirect steering ???? https://rbentonline.org/YaBB.pl?num=1512938275 Message started by Cheve11e on Dec 10th, 2017, 2:37pm

Title: converting direct to indirect steering ???? Post by Cheve11e on Dec 10th, 2017, 2:37pm [smiley=duel.gif] well, I'm sure it actually could be done, but really I'm just looking to get a tighter/smaller turning circle from lets say a Catrike Trail?  I think stock it has 16.5' and it would be very helpful in my situation (because I am disabled and use the trike fir WAY more than just 'Sport riding').  Anybody have any good ideas about this OR should I just find a used GreenSpeed - I think they have about 12".? :) Thanks :) David

Title: Re: converting direct to indirect steering ???? Post by jrob_bent on Dec 10th, 2017, 9:22pm Cheve11e wrote: [smiley=duel.gif] well, I'm sure it actually could be done, but really I'm just looking to get a tighter/smaller turning circle from lets say a Catrike Trail?  I think stock it has 16.5' and it would be very helpful in my situation (because I am disabled and use the trike fir WAY more than just 'Sport riding').  Anybody have any good ideas about this OR should I just find a used GreenSpeed - I think they have about 12".? :) Thanks :) David Check out recumbents.com . It can and has been done. You can use linkage joints, cable, or even bicycle chain for indirect steering.

Title: Re: converting direct to indirect steering ???? Post by Cheve11e on Dec 12th, 2017, 10:06am Thanks - Ill check it out

rbent Forum » Powered by YaBB 2.1! YaBB © 2000-2005. All Rights Reserved.